06-01-2009 11:57 PM
Hi,
I am very new to LabView and this is the first assignment that i need to carry out.
I need to set the DRC 91C Heater % to 20 by creating a program using LabView.
I tried placing an DRC 91C control on the front panel. Now how to use it.
Can someone help?
I have read the Manual for DRC 91C from Lake Shore but it only mentions what parameters to use to execute W3.
But where should i give there parameters (N1N2N3,N4N5N6,N7N8N9,N10,N11N12N13) .
Any type of info will be helpfull.
Please Guide a bit.
Regards,
Shriniket Sarkar
06-02-2009 12:32 AM
Hey guys atleast give me some hint how to go about this ?
Where can i read about this ?
Any lead would be very helpful.
Regards,
Shriniket Sarkar
06-02-2009 03:08 AM