I have a PCI-1424 board (using a Dalsa CL-C6-2048A camera) and I want to use
the external trigger lines
(0,1,2,3) to synchronize the line frequency of the camera with a special
lighting system. The sync-signal is
generated by a mirocontoller system, which also synchronizes the lighting
system.
How can the trigger lines be used and how can the trigger modes (start of
acquisition on rising or falling edge,
polarity, direction etc.) be selected?
Michael Nestler
University of Technology Graz, Institute of
Electrical Measurements and Measurement Signal Processing
Kopernikusgasse 24/IV mailto:nestler@emt.tu-graz.ac.at
A-8010 Graz Tel: +43-316-873 7274
Österreich Fax: +43-316-873 7266
Web: http://www.emt.tu-graz.ac.at
