Hello,
I am trying to do a simulation of a Solidworks assembly through SoftMotion Module in LabView, I followed the tutorial that is from the official NI site which corresponds to the SortingMachinge.SLDASM and everything went well.
But, when I stop the simulation then run it again the parts that are related to the motors suddenly jump and go faraway even before I start any VI.
I tried it on another simple assembly, the same thing happened, the simulation worked the first time very well but when I stop the simulation then start it again the parts jump very far away in Solidworks.
Any suggestions or hints?
Or is there a proper way to stop simulation then restart again later?
I have it as a project for my university and I tried many assemblies all do the same, work fine first time then when I start the simulation again it starts successfully but the parts with simulation motors on them jump far away.
I am working on LabView 2018 (32-bit) and SolidWorks 2019
Thank You!
