From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Push Button from Arduino via Labview

Push Button from Arduino via Labview

‎08-23-2020 12:02 AM

Hello,

I am trying to control the button from Arduino via Labview in order to activate a DC motor in specific speed. I have many buttons but I would like to control only the button 2. Unfortunately is not working and I can observe that the TX and RX lights are blinking. This is with LIFA.

If I use the LINX, photo 2, I can see that the TX and RX lights are always on (which is good), and then when I push the Boolean in labview, also the L button goes on, which means it takes the command, but the button is not doing anything.

 

Alexis_Koul_0-1598158581015.png

Alexis_Koul_1-1598158802721.png

 

 

0 Kudos
Message 1 of 1
(1,164 Views)
Reply