(LV 7.1.1)There appears to be a bug with the "VI Modifications Bitset" property:1. In the attached llb, open "main.vi"2. Open "Cluster" for editing (it's a type def)3. Open "Sub1" for editing, and make a change to it (move a control slightly)4. In the attached llb, open "ModsBitsetBug.vi", look at the block diagram, then run it5. Notice that the "Mods.VI" property returns a different value for the type defs depending on whether it is above or below "Mods.Block Diagram"Here is what I get:Can someone confirm this?JaegenMessage Edited by Jaegen on 03-28-2007 12:08 PM

Modifications Bitset Bug

I think I found our confusion. I was running 8.2 and the behavior has changed!

In fact, I have confirmed that this is a bug in 7.1, but seems fixed in 8.2

Good catch.

Message 11 of 13

(738 Views)

Author

Thanks for this.

Could you clarify a bit? Does "Ignore Errors inside Node" not work at all for 7.1, or just for these properties?

Jaegen

Message 12 of 13

(735 Views)

I can't say that I know the full scope of the problem, but it seems to happen in this VI also. So if I had to guess, the feature Ignore Errors... doesn't seem to work properly in 7.1

Message 13 of 13

(729 Views)

LabVIEW

Modifications Bitset Bug

Re: Modifications Bitset Bug

Re: Modifications Bitset Bug

Re: Modifications Bitset Bug