Missing assignment to tunnel - LabVIEW - NI Discussion Forums

[-Shadow-]

I'm programming a VI that makes a calibration file from an RF-generator.
It works over the LAN and goes to a GPIB interface, no problems there.
But when communicating with the power meter I can't close the loop.
A copy of my VI is attached thanks in advance.
The other loops and devices communicate perfectly can't see what my mistake is
I've been debugging for three days.

[becktho]

Hi

You have to tunnels there which are above each other. Just click the tunnel and move it down with the down-arrow key. Then you'll see that there are two tunnels.

Thomas

Message Edited by becktho on 05-02-2005 12:56 PM

[-Shadow-]

Thank you very much