I have for loop
in which the main program will be running. As shown in the attached file I have
two levels and two delays. These are different instruments am controlling using
GPIB and Serial Interface.
Coming to the point, first the level 1 should be set outside
the loop and delays might/might not be inside the loop. Here are the steps I
have to do.
1) Set
Level 1 outside the loop (if possible)
2) Now,
with that Level 1 for certain number (say 50) of main program for loop counts,
the delay 1 should be set. After 50
counts, the delay 2 should be
switched on.
3) Now,
after 150 counts, Level 1 should be
changed to Level 2 (which had different parameters set), and now the delay 1 should be set. After 50 counts,
the delay 2 should be switched on.
4) This
process will go on unless I stop the program.
I tried it in a different way with the for loop but by using the loop inside the loop, there is more delay which is not desirable for our application. I appreciate your support.
