LabVIEW 2012 SP1 FPGA Module not linked to Development Environment

[JohnF3]

After a installation of LabVIEW 2012 SP1 onto a Windows 7, 32 bit PC the FPGA Module is not seen by the development system (Noted in NI MAX).

I have following warning in the project

Further actions taken:

Verified Windows firewall is turned off

Verified have administrator permissions

NI RIO is compatible (NI R Series Multifunction RIO 12.1)

Downloaded & installed ‘LabVIEW 2012 SP1 Patch f9.

Downloaded & installed ‘LabVIEW Run Time 2012 SP1 Patch f9.

Ran repair of RIO drivers & Xilinx 10.1

Uninstalled & then reinstalled all software

Any advice would be appreciated

[JohnF3]

Uninstalled all software & re-installed.  This time installed FPGA Module at the same time a LabVEW2012 & now OK