LabVIEW 2010 crashes when attempting to open vi

[bunnykins]

Help !

When I attempt to open my vi in LabVIEW 2010 it just crashes and shuts down.  I have attached the vi, if anyone can help me and perhaps recover the vi file or at least so that I can see the Bock Diagram it would be most appreciated.  Otherwise I'll have to start over from scratch.

[WayneS1324]

Opens fine on mine.

A jpg of the block diagram is attached.

[bunnykins]

Dear WayneS1324,

Would it be possible for you to rename the vi file and send back to me please?  Many thanks for the .jpg  you have been a great help.

Regards,

Warren

[WayneS1324]

Try this.

[bunnykins]

Thanks but I note that you must be using LabVIEW 2011 ?

I'm using LabVIEW 2010 and cannot open your rename.vi file.

[WayneS1324 · Accepted solution]

Sorry... Here's 2010.