How to write TDMS file with two parameters ?

[deepen_solanki]

Hello. Im using LabVIEW 2013 with myRIO 1900. I need to know how i can write a tdms file with two parameters. Ive converted my data into waveform using DDT and then wired it into the TDMS write. When i open the file all i get is the sensor readings. I need to know how i can show variation of my sensor input with time or input coming in from any other channel. 

Thanks in advance. 

[jwscs]

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000YGxCCAW&l=en-US

waveforms only have one timestamp and a delta, which means in waveforms each datapoint is delta-time later than the previous one .. in other words the difference between two datapoints is uniform

since my own measurements are with varying deltas, i have my tdms with a timestamp channel and seperate data channels, so for every data entry there is a corresponding timestamp.

depending on your volume of data stored in tdms it might help doing that yourself

[jwscs]

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000x4PcCAI&l=en-US this was informative

[deepen_solanki]

Thank You. That was helpful 🙂