Hi all, I have a VI that basically automates a temperature ramp. once the Ramp Temp button is pushed the VI pull two rows of data from a .csv file (Setpoint and duration) to create a temperature ramp. All seems to work find but in the case that I would like to disrupt the ramp and go back into manual mode, I can't stop the VI while it's holding its wait time. Is there a simple way besides aborting the whole VI since this is a small part of bigger VI? Thanks in advance!

LabVIEW

Hi,

Technically, it is 20mS at most.

You are technically correct,

It's correct as long as we don't talk about using SI units properly! 😄

Best regards,
GerdW

using LV2016/2019/2021 on Win10/11+cRIO, TestStand2016/2019

Message 11 of 11

(576 Views)