How to make while loop to run for a certain time?

[oistvan]

Dear All,

I would like to make a while loop to run for a certain period of time (few hundred miliseconds), after which it should stop. Can somebody give me an advice concerning this?
I apologize for the trivial question, but I´m at a very beginner stage of my LabView life.

Thank you very much in advance.
Istvan

[Tom Haggerty]

Here is one solution

Tom

Message Edited by Tom Haggerty on 05-30-2007 01:20 PM

[Dennis_Knutson]

Or this.

Message Edited by Dennis Knutson on 05-30-2007 11:40 AM

[oistvan]

Thank you!

regards,
  oistvan