How do you detect all edges with IMAQ extract contour IV?

[Dander]

I am trying to use the vision development module to detect all of the edges in a pictue and not just one. The idea is by the end I will be able to detect all of the red in the attached image. However the extract contour with only give me one brighter section of the image.

All help greatly apreciated

[Greg_S-Video]

Hello Dander

I would just like to let you know that I am looking into this issue for you.  Thank you for your patience.

[Greg_S-Video]

Hello Dander

I wanted to apologize to you.  I saw that an identical issue was being handled by a different engineer and we consolodated that this other individual would handle it.  Have you been able to come to a resolution to this problem?

I have this notion that you may be able to find the outer most edge, take note of it's location and cut out the image bounded by that edge and then run the edge detection system again to find the next outer most edge and repeat.  Have you made any progress on this issue?  I'm happy to provide any further insight into the situation.