Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

How do I change an analog output to zero when an error occurs?

How do I change an analog output to zero when an error occurs?

‎01-13-2008 05:35 PM

I'm trying to make it so that when the VI I have encounters an error, the analog output goes to zero volts, or no output, rather than the last value when the error occurred.

Is there a way to do this?

The card I'm using is a NI-DAQ 6063.

Thanks
0 Kudos
Message 1 of 2
(2,086 Views)
Reply

Re: How do I change an analog output to zero when an error occurs?

‎01-13-2008 06:53 PM

duplicate post
0 Kudos
Message 2 of 2
(2,081 Views)
Reply