From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I am new in using labview , i am using labview 2010 but for some reasons my front panel is not showing the options of 'signal processing' and 'control design & simulation'
Front Panels show Controls and Indicators, the Block Diagram shows functions and wires, and is where you would look for Signal Processing and functions in the CDS Toolkit. Type Ctrl-E and look in the Block Diagram.
Oops. It's probably going to hit a lot of us who are "regulars" ...
I just did a "Mark All As Read" last night when I saw a lot of last posts from 2012. It looks like things are back to normal for me after that.
There are only two ways to tell somebody thanks: Kudos and Marked Solutions Unofficial Forum Rules and Guidelines "Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
