06-20-2018 07:11 AM
Hello!
I am using Labview 2017 to run a co-simulation with Multisim 14.1. A 3 phase IGBT inverter has been made, along with a bare-bones VI to run the co-simulation. When I want to run the Labview VI, an error message pops up, telling me the following:
Error -2367 occured at External Model in Untitled 14/Control & Simulation Loop
Possible reason(s):
Control Design and Simulation: The shared library corresponding to the external model returned an error.
Launching Multisim was unsuccessful. (L404)
I've tried simplifying the Multisim design to see if the error was resulting from there. This however proved to be unsuccessful. Would anyone know how to solve this problem?
See attachments for the LabVIEW and multisim design that I used.
Thanks in advance!
08-02-2018 04:10 AM
Hi Learonys,
How are you getting on with this issue?
The error you are receiving corresponds to an error in Multisim with the time step. Refer to this article for more details:
Multisim Simulation Error: Time Step Too Small - National Instruments
Kind Regards
Elmuzir