Enter Data to a Simulink Model (Simulation Interface Toolkit) SIT

[IamTurok]

Hi to every one!

I am on my final semester, and I have a problem with entering the data to a simulink block using SIT. I have succesfully linked simulink and labview but as you may know some parameters of a simulink block are shown as in the next figure:

I did the mapping to the VPS parameter on the mapping control on the SIT Manager using a different controls such as knobs, arrays, string, etc....but none of the seem to work.

So my question is what type of control do I have to use in order to send an array of data such as [x x x] like shown for the VPS parameter. Please answer as soon as possible...I would apreciate it very much because I have to give my final paper this weekend ... THANK YOU VERY MUCH!!!!

Carlos Rivera

Electrical/Electronics Engineer

Universidad de los Andes

Bogotá - Colombia

[Lucianogob]

Please take a look at this topic forum:

http://forums.ni.com/t5/Real-Time-Measurement-and/connect-Multiple-VIs-with-one-Simulink-model/m-p/1...

Thanks.

Best Regards

[muqz]

i have a problem. i have installed simulink interface toolkit. but i cant find it on labview. do i miss something?? i have matlab 7 and microsoft C++ 05.and have labview 2009. plz tell me whts the problem