Dynamic Labview Again!!

[Special K]

HEELLP:

I'm using the OPEN VI reference anf then the CALL BY REFERENCE, and it does executes it, but the VI wont open ( the front panel of the VI I'm calling). Could someone explain me, spet by step how to do it.

I have done everything you told me before but nothing works.

[MikeS81]

duplicate post -- continue here

[altenbach]

There is no need to start a new thread. Let's keep this discussion in one place only.

Thanks! 🙂

[jon_mcbee]

Without more detail into what you are trying to do, below is how to open the front panel of a VI by reference.

 

I didn't realize this was a duplicate post until it was too late.  My apologies for the negative reinforcement.

Message Edited by jmcbee on 10-13-2008 02:21 PM