Driver for MM4000 series (motion controller) for labview 6.1 (gpib)

[LudovicF]

Hello,

I need the instrument driver for a newport motion controller MM4006.
I found the driver for MM4000 series, it could be ok, but I need it for labview 6.1 and not  for labview 7 or 8.
Is it possible to find this driver for older version of labview than 7 or 8?

Thanks

Best regards.

Ludovic

[Mathieu_R.]

Hello,

If the constructor of your instrument is not able to provide you the driver for LabVIEW 6.1, I'm afraid you have to upgrade your LabVIEW version.

Cordially,

[Dennis_Knutson]

Hold on a second. If you were to post the driver, someone could resave it for an older version. Since the driver was originally written in 1998, I'm pretty certain there won't be any conversion problems and I'm equally certain that the 6.x version existed at one time on NI's site.

If you post the 7.0 version, I'll do it.

[LudovicF]

Heelo.

I post the driver for labview 7, if someone can save it in labview 6.1 version.

Thanks

[Mathieu_R.]

Good idea, I'm not sure of the result, but... Here is the zip file (aviable here).

(oups, you were faster ^^)

Message Edité par Mathieu R. le 12-08-2006 05:19 PM

[Dennis_Knutson]

Here's the 6.1 llb.