Hi Guys, Labview newbie here and am trying to build a Labview simulation of a basic sensor. Here is the question I can't seem to figure out. Basically I have one input - a on/off switch. When the switch is on, it will simulate a crucial event where the user must pay attention to it. This will light up an LED for this event. When the system is off, the system is running fine and there is an led indicator for that also. For the crucial event, I want the LED to stay on until the user sees it and acknowledges it --> he or she can acknowledge the event until he/she clicks on the LED which will turn it off. This LED will stay on even if the on/off switch is in the off state because I want the user to see that the crucial event actually occured. I have this so far (really basic):I want the bottom LED to stay on until it is acknowleded! Any insights on this would help! Thanks!

You would use a shift register for the historic status, e.g. as follows (LabVIEW 8.5): Message Edited by altenbach on 11-01-2008 11:21 AM

Some courses and learning paths on NI Learning Center may not appear on learner dashboards. Our team is actively investigating.

If you encounter access issues, please contact services@ni.com and include the learner’s name, email, service ID or EA number, and the list of required courses.

LabVIEW

Creating a latch with an LED indicator control

Solved!

Here's what I would do.

LabVIEW Champion.

Download All

Message 11 of 12

(833 Views)

Thank you so much! This was exactly what I needed.

Message 12 of 12

(814 Views)

LabVIEW

Creating a latch with an LED indicator control

Re: Creating a latch with an LED indicator control

Re: Creating a latch with an LED indicator control