Good morning, I'm attempting to create a simple signal genorator that will send an analog command signal to a device and then read the devices position feedback. (Check out the attached VI) The program must accept the users input for DAQ Max and DAQ Min Voltage, and I/O Analog channel selection becuase any daq from 6008 to 6215 will be used. I think the best way to set this up is with virtual DAQ channels. I found another example on the forum, but it didn't work for my setup. I'll be very grateful with any suggestions you have! Thanks,Christopher

Found a solution! Thanks everyone. -Christopher

ni.com is currently undergoing scheduled maintenance.

Some services may be unavailable at this time. Please contact us for help or try again later.

LabVIEW

Solved!

Message thread has moved to here.

Message 11 of 11

(309 Views)