From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I have a Robotic Brushless DC Motor Controller, FBL2360,I try to communicate it with labveiw for supervision the motors, I try to communicate with the serial port of the PC but it doesn't work, could someone help me with this problem.
you found here the VI that i make it to communicate with the controller
Set the Termination Character to match what is being sent by your device
I didn't see any mention of termination when I skimmed th manual. But anything will work, like if the device always puts a CR or LF or even semicolon at the end of every data sent.
Set your VISA read "bytes to read" to a value higher than the number of bytes you ever expect to receive.
Now when LabVIEW is receiving data, it will "read" until it receives the termination character or times out.