ni.com is currently undergoing scheduled maintenance.

Some services may be unavailable at this time. Please contact us for help or try again later.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Communicating with Motion Controller

Communicating with Motion Controller

‎08-13-2012 06:59 PM

I have an ESP300 Motion Controller. I can communicate with it via HyperTerminal. However, when I try to send commands using NI's Measurement and Automation module, I get nothing. I also get the attached error when trying to send commands with the VISA Write command in LabView. Anyone more knowledgable than me on the this? 

0 Kudos
Message 1 of 2
(2,462 Views)
Reply

Re: Communicating with Motion Controller

‎08-13-2012 07:17 PM

same problem as posted at http://forums.ni.com/t5/LabVIEW/VISA-driver-for-Serial-Connection/td-p/2121878

0 Kudos
Message 2 of 2
(2,458 Views)
Reply