Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Amplify signal in labview

Amplify signal in labview

‎04-25-2007 07:21 PM

I would like to know if it is possible to amplify a signal aquired by a DAQ card in LabVIEW.
 
Thank you,
shereen
0 Kudos
Message 1 of 2
(3,070 Views)
Reply

Re: Amplify signal in labview

‎04-25-2007 09:12 PM

Once the signal is acquired it's just a list (or we would say an array) of numbers. You can multiply the list of numbers by a constant bigger than one. I wouldn't call this amplification though, I would call lit scaling.
0 Kudos
Message 2 of 2
(3,064 Views)
Reply