Hello, I would like to design a user interface where the user can define the analog voltage level of a specific analog channel for a certain amount of time. Essentially, I need a 2D array where the columns represent each channel on the PCI 6711 board (Ao 0:3) and the rows represent a specific amount of time for each row to last. I'm assuming there would need to be another 1D verical array with integers representing the number of clock ticks each row will last for. I can't seem to find any example code where this is implemented, so examples or suggestions would be grealty appreciated. I have included a picture of a different program that performs this and I would like to mimic this setup.

Pass the array through a for loop. This gets each row. You can then use the array subset function to get the columns with the voltage setting. This gets wired to a DAQmx Write set for n channels 1 sample. Index the time column and wire it to a delay. Try it and post back of you get stuck.Sorry, but the above answer does not make any sense to me.

LabVIEW

2D Array Analog output across 4 Lines (PCI 6711)

Solved!

Author

I'm terribly sorry for not reading your earlier responses more clearly, after looking back and following those instructions I have successfully built what I needed. Thank you very much for your help.

Message 11 of 12

(350 Views)

Good news.

Message 12 of 12

(347 Views)

LabVIEW

2D Array Analog output across 4 Lines (PCI 6711)

Re: 2D Array Analog output across 4 Lines (PCI 6711)

Re: 2D Array Analog output across 4 Lines (PCI 6711)