Multidrop network using ENET485.

[Hec]

I built an RS485 multidrop network of 32 ultrasonic sensors, where each one has an unique address. The network is connected to my PC by an NI ENET 485 device. I would like to know, (using Labview) how to make a program to log data of each sensor. How to identify data of each particula sensor.

(I know how to read data of one sensor).

hecrm@yahoo.com.au

Thanks

Message Edited by Hec on 04-27-2006 10:11 PM

[JasonSmith]

Duplicate Post.  Please see the response to this question here.