Home Community Discussion Forums Most Active Hardware Boards Instrument Control (GPIB, Serial, VISA, IVI) Topic

Instrument Control (GPIB, Serial, VISA, IVI)

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

GBIP-ENET/100 device passes NI 488.2 Troubleshooting Wizard, but can't scan for instruments

GBIP-ENET/100 device passes NI 488.2 Troubleshooting Wizard, but can't scan for instruments

‎10-17-2014 06:34 PM

I recently configured a GBIB-ENET/100. It passes the NI-488.2 Troubleshooting Wiazrd. However, when I go to scan for instruments I get the message "The GBIB1 (GPIB-ENET/100) interface has been configured.". It then tells me to run the Troubleshooting Wizard to correctly configure the device, the Troubleshooting Wizard shays that everything is fine. Any help resolving this would be appreciated.

0 Kudos
Message 1 of 3
(4,732 Views)
Reply

Re : GBIP-ENET/100 device passes NI 488.2 Troubleshooting Wizard, but can't scan for instruments

‎10-18-2014 07:08 AM

Under ni-max, under device and interface, if you click on the gpib-ENET/100, you should be able to scan for device. Be sure you don't have 2 device with the same GPIB address. In my case, we have 3 100 and 2 1000, never have issues. But, I think we update de 100 firmware (to be verified).
0 Kudos
Message 2 of 3
(4,716 Views)
Reply