Hi all,I'm currently sending voltage levels from my 10 bit ADC to my com port. The microcontroller then converts the ADC output to a float and sends it through the serial port using the statementprintf("%04.3f\n\r",result);and in hyperterminal i receive values like 2.500 2.501 2.501 etc etc..I've tried using Visa and plotting the info but i keep getting problems. Pls refer to image.I'm getting the correct readings from the READ STRING in indicator (2.500 2.501 2.501) but my VOLTAGE READINGS gets the first reading correct 2.500 then flats out at 0 from then on.....imageMessage Edited by ghostz13 on 02-27-2007 02:02 AM

Instrument Control (GPIB, Serial, VISA, IVI)

Author

Hi Eric,

Could you post it in Labview 8.0 format? Thanks!

Regards,
Gerard

Message 11 of 13

(1,059 Views)

I don't know if Eric can do this

But I can.

Message 12 of 13

(1,055 Views)

Author

Haha sorry for the mix up.. thanks again KC!!

Message 13 of 13

(1,052 Views)