ni.com is currently undergoing scheduled maintenance.

Some services may be unavailable at this time. Please contact us for help or try again later.

Home Community Example Programs Example Code Document

Example Code

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
ASK A QUESTION

Transfer Graph to a Sub VI

by: Member
‎06-19-2011 02:43 PM
Last Edited by: Member Example_Scrubber_Suryo ‎11-01-2017 03:36 AM

Products and Environment

This section reflects the products and operating system used to create the example.

To download NI software, including the products shown below, visit ni.com/downloads.

    Software

  • LabVIEW

Code and Documents

Attachment

Download All

Overview
To transfer waveform graph data to and from one another.

Description:
These VIs allow you to transfer waveform graph data to and from one another. The main VI (InputData.vi) generates two different waveform data. Then transfers data to different waveform.

Instructions:
To implement this example:

  1. Run the VI
  2. Turn On the Transfer to Transfer the Graph


To execute this example:

  1. Install the required software.
  2. Open the VI and refer the Implement Steps


Requirements
Software
LabVIEW 2012 or compatible

Hardware
-

bd.pngfp.PNG

**This document has been updated to meet the current required format for the NI Code Exchange.**

Best Regards,
Jignesh Patel
Principal RF Software Engineer

Example code from the Example Code Exchange in the NI Community is licensed with the MIT license.

0 Kudos