Operator interface switch to control SSR NI9485

[Skinner2k3]

I am struggling to control a SSR module from Signal Express.

The setup is a cDAQ9188 chassis and NI9485 8ch SSR module switching a 10v supply.

I have a DAQmx Gen - Digital line output set to control the NI9485 and if I toggle the value to write in the configuration tab between high and low the SSR does function.

What I cant seem to get to work is controlling the output from a toggle switch in the Operator interface, I have been into the switch bound parameters and selected the module and port.

This is my first time with NI software/hardware so I am guessing I am missing something obvious, if anyone can point me in the right direction it would be much appreciated.

Thanks

[Dennis_Knutson]

Since the hardware is working, you should post to the SignalExpress board - http://forums.ni.com/t5/SignalExpress/bd-p/380

[Skinner2k3]

Can I move the post or should I repost?

Thanks

[Dennis_Knutson]

You can click on Options and request the moderator to move it.

[Skinner2k3]

Thanks