03-02-2017 10:13 AM
I need to design a board with a specific transmission line length. When using the 6556 and a 1M cable, how can I guarantee the line length? Where should I assume the start of the transmission line is(Card connector, end of cable, end of connector)?
03-06-2017 01:32 PM
What do you mean you need to guarantee the line length?
The signal will travel the entire length of the cable, end-to-end.
What cable are you using?
03-06-2017 01:41 PM
Hey Red,
I need to characterize my device with a 15cm transmission line. If I want to use the HSDIO(I have the 1M Cable), how do I guarantee the length?
03-07-2017 04:51 PM
Answering this question might require taking a step back and giving the full picture to receive a helpful response.
You can’t change the internal length the signal travels, so setting the output as length zero likely makes sense. Then it’s just a matter of measuring the length you’d like.
Will you be modifying the cable? What’s the plan?