Read and decode .dbc and .a2l files using Labview VIs?

[Christ0phe]

Hello,

I am using Kvaser CAN interfaces and Labview 2012. Since those are not supported by MAX, I would like to know if there are some Labview Vis available (in NI-CAN?) that perform the task of reading and decoding .dbc and .a2l files.

Thanks

Christophe

[Gibson]

decoding of a CAN DBC files is offered by the XNET API, even to convert a raw frame into a physical signal can be done be XNET Conversion API.

so I recommend to install NI-XNET and check the example finder,

Decoding of A2L Files can be done by using the NI ECU Measurement and Calibration Toolkit.

refer to

https://www.ni.com/en-us/shop/product/ecu-measurement-and-calibration-toolkit.html

[Christ0phe]

That is good starting point for further investigations. Thanks.