Is there a way to reconfigure a PXI-7344 motion controller with its two 68-pin connectors so as to use it as a DAQ device that would receive the signals from a NI ELVIS workstation. The 7344 has a "motion I/O connector" and a "digital I/O connector". Analog outputs are even possible if I remember well, as well as digital.
The card does has some analog input and outputs. I would check the manual here: https://www.ni.com/docs/en-US/bundle/370838b/resource/370838b.pdf The DAQmx API with a DAQ card is going to be much better than interfacing with a motion card, but you should be able to read off it at the least.
Thanks for the overall advice. The hyperlink to the pdf returns a "page not found", either for 370838b.pdf or simply 370838.pdf . If you could be a bit more specific about that PDF file, that would be very much appreciated.
