05-29-2013 12:44 PM
Hi, I am using Arduino with LabVIEW to automate an extruder machine for my masters project. Can you please tell me how to obtain wire diagram for the Arduino circuit after completing the graphical circuit in LabVIEW? Can I get some more examples on LabVIEW interface Arduino related to motion control and automation?
Thanks & regards,
Akshay Wankhede
05-30-2013 09:25 AM - last edited on 11-04-2014 01:40 PM by C-T
Hello Askhu,
LabVIEW plus Arduino sounds like a fun combination!
SparkFun even sells a kit for it, which is handy because they also provide a good starting point for a support community:
https://www.sparkfun.com/products/10812
And we sell an interface toolkit that may be helpful:
http://sine.ni.com/nips/cds/view/p/lang/en/nid/212478
And our own community page appears to start here:
https://decibel.ni.com/content/groups/labview-interface-for-arduino
I don't know much about any of this, but these seem like good places to start looking for more information!
Good luck,
Edwin!
11-14-2013 07:15 PM
add other useful links, greetings
http://sine.ni.com/nips/cds/view/p/nid/209835
http://vishots.com/getting-started-with-the-labview-interface-for-arduino/