Editing Chart Properties thro' Properties dialog crashes LabVIEW 8.5.1

[parthabe]

Anybody please redo these simple steps to reproduce what I inferred...

1] Create a New VI & place Waveform Chart in it.

2] Rt-click Properties & launch the Chart Properties dialog.

3] Check Stack Plots & set 3 in the Plots Shown field.

4] Give OK & return back to FP.

5] Move the Plot Legend slightly to the right side out of the Chart.

6] Now, again launch the Properties dialog.

7] Keep checking-unchecking the Show Digital Display option & the Stack Plots option continuously for some time.

At some point of time after a few fast clicks, be idle for a slightly longer moment, after unchecking the Show Digital Display option.

Now, LV suddenly crashes giving the message in the attached image.

[Mathan]

Dear partha,

I have 8.5 and i tried  . But unable to reproduce the crash  . May be it will happen in 8.5.1 only.

Thanks,

Mathan

[Pie56694]

Hi Partha,

I submitted your findings and a link to your post to NI Research and Development as a new Corrective Action Request (CAR).  You can look for CAR ID 118302 in the "Important Bug Fixes in LabVIEW" document that ships with every new release.  Thank you very much for your feedback.

[Pie56694]

---

@Pie56694 wrote:
Hi Partha,

I submitted your findings and a link to your post to NI Research and Development as a new Corrective Action Request (CAR).  You can look for CAR ID 118302 in the "Important Bug Fixes in LabVIEW" document that ships with every new release.  Thank you very much for your feedback.

---

This was reported to R&D (# 118302) for further investigation.

[parthabe]

Thank you Steve, for your continued efforts.

[Pie56694]

Hi Partha,

No problem!  I had to re-post because my original did not contain the string that NI R&D uses to follow-up on forum CARs.  Thank you for your great work on the forums!