Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 

On the timeout phenomenon of PXIe-8840 real time system

In the development environment, I found that this frame has a timeout every 38 to 40 seconds.

 

However, after I downloaded and deployed the real-time program to PXI (components : PXIe-1082 chassis, PXIe-8840 controller, PXIe-6738 and PXIe-4497 card), I estimated that this frame also timed out, which showed that the time required to see the signal trigger increased slowly (as shown in the figure 2, there was a deviation of 0.6 ms in about 4 minutes); I want to solve the problem of frame timeout, but it will what is the reason for this?

 

Thank you in advance for checking and helping!

Yuyu1994_0-1604048639665.png

Yuyu1994_1-1604048672232.pngYuyu1994_2-1604048734815.png

 

 

Download All
0 Kudos
Message 1 of 3
(1,061 Views)

Hello

 

By saying timeout you mean that program gives timeout error?

Also, I noticed DAQmx run vi in the timed loop (at the bottom), this is not usual and right way to start the acquisition/generation.

 

__________________________________________
The best way to thank, is to give KUDOS
0 Kudos
Message 2 of 3
(995 Views)
Thank you for your review and guidance. Timeout means that the acquisition card does not seem to be able to achieve a very accurate sampling rate. DAQmx reads VI every 20 seconds, and the waiting time for data acquisition exceeds 1ms.
0 Kudos
Message 3 of 3
(971 Views)