I am trying to connect my cRIO to the Software Calibration Management, but im not sure why my target doesn't show when i call it using its IP on the network. Also, i dont know how to install the Software Calibration Management toolkit on the cRIO as shown in the manual picture attached. Any Ideas Please.
I'd recommend joining the group "NI POWERTRAIN CONTROLS USERS" and posting this there. You can also create a Service Request and call NI support, then ask to be routed to the Powertrain Controls SE group (it might take a few minutes of routing).
Hope this helps!
Andrew T. "His job is to shed light, and not to master" - Robert Hunter