From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I am setting up my PXI-6115 in a PXI-1033 chassis with a BNC-2090A accessory. I am making good connection between BNC and PXI-6115 (Power LED on) and I am connected and installed correctly on my PC. However, I am trying to use MAX to generate some signals and am only receiving 0.8V on all analog outputs and the chart displays 10V on all analog inputs. This occurs even with the BNC accessory disconnected and no signals are being input into the system. I was able to observe a signal on my oscilloscope on the output channels when generating a sine wave, however it was rectified and biased and measured different voltage levels than what I tried to create in MAX. Also, when I try to self-calibrate the card, it gives me an error, so maybe it needs recalibrated.