07-30-2009 12:08 PM
I can't seem to get the M & A Explorer to recognize my PXI slots.
The chassis shows up but slots 2,3 & 4 come in as unknown.
I've got a PCI-4472 Dynamic Signal Acquisition board installed in slot 2 and I'm using a laptop with XP installed.
First time I've tried to set up this chassis and I'm not sure where to go from here.
08-03-2009 11:44 AM
Hi TMac,
Is the card showing up under Devices and Interfaces? What about in device manager?
Regards,
Sammy Z.
08-03-2009 12:03 PM
Sammy Z
It does show up on the "Devices and Interfaces" as an empty chassis.
Under Device Manager I have a 02 Micro 0Z711EZ1 Memory Card Bus Controller under PCMCIA adapters.
This is the only PCMCIA device I have installed so I am assuming that is the PXI-1031.
I also show a "Other PCI Bridge Device" under PCI Bridge Device that does not have a driver installed
TMac
08-04-2009 02:57 PM
TMac 5437
Can you please attach a screenshot of MAX as well as a screenshot of the Device manager when viewed by connection. View>> View by Connection
Also Let's Ensure that NI-DAQmx is installed. To verify check under the software tree of Measurement and Automation Explorer and verify that NI-DAQmx is present there.
You say that the Chassis is empty what cards do you have other than the DSA device?
08-04-2009 03:36 PM
Can't seem to get a screen shot into this reply.
I tired dropping it into Word and attaching the file but when I preview it there are red "x's" where the pictures were.
Tried copying and paste from Word and it is garbled code.
How do can I get a screen shot into this window/reply.
08-10-2009 11:02 AM
Hi TMac,
What is the extension of your image?
Are you using the tree looking icon or the add attachements from the bottom?
Regards,
Sammy Z.