From Friday, January 17th 11 PM CDT (January 18th 5 AM UTC) through Saturday, January 18th 11:30 AM CDT (January 18th 5:30 PM UTC), ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards PXI Topic

PXI

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Achieving 10G bit/sec throughput using LabVIEW host code with UDP protocol

Achieving 10G bit/sec throughput using LabVIEW host code with UDP protocol

‎06-30-2023 09:33 AM

Hi

I m using pxie1095 chassis with Pxie 8861controller and Pxie 8238 10g ethernet card. 

I have enabled jumbo frames and tested the 10 G throughput with nttcp and in task manager I m able to see that the ethernet throughput reaches 9.9 Gb/s. I want to stream UDP data at 10 g speed using LabVIEW host code. I am using a while loop for which I m controlling the iteration speed using high precision wait function. Inside the while loop the UDP write function is present. In every iteration I m sending 65507 bytes of data. I m not able to achieve 10 g streaming with this case, because of error code 55 (network operation busy) occasionally coming from UDP write function error out terminal.

I really appreciate any suggestions on how to make this 10g streaming throughput possible using LabVIEW host code with UDP protocol.

Thankyou!

0 Kudos
Message 1 of 1
(1,008 Views)
Reply