Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 

Timer Circuit

I am trying to build a circuit using 4060BP that would generate a 2Hz clock using a 32.768kHz crystal oscillator and then generate a 1Hz clock using 4013BP. However, when I run the circuit the LED does not turn on/off at 2Hz and 1Hz speed and when I check the frequency using an oscilloscope, I measured kilohertz of frequency. I was wondering if someone could help me figure out what is wrong with the circuit. The circuit is attached below.

0 Kudos
Message 1 of 4
(711 Views)

Привет! Попробуйте так подключить кварц. А второй делитель сами подключите, важно, что правильная генерация заработала...

tipa_0-1686123555533.png

Миги.gif

0 Kudos
Message 2 of 4
(645 Views)

Hello! I tried to run the circuit but I am not getting a 2Hz pulse at PIN 3.

0 Kudos
Message 3 of 4
(622 Views)

Я подправил модель кварца, задал начальный заряд индуктора и схема начала выдавать то, что нужно... 
А вот с библиотечными параметрами кварца получаем частоту в 1000 раз больше

tipa_1-1686473089571.png

 

tipa_0-1686473009056.png

 

tipa_0-1686472273022.png

 

0 Kudos
Message 4 of 4
(561 Views)