10-03-2016 08:21 AM
I am running student version multisim 14. I made a very simple circuit and place two multimeter and run dc analysis.
But the problem i am facing that i am getting calculation window but multimeters not showing any simulation value.
can anyone help me to understand this please.
Solved! Go to Solution.
10-13-2016 04:55 PM
Hi shabeesatsangi,
The multimeter components are meant to be used during interactive simulation. When you run DC Op analysis, you will see the results in a table in the grapher.
To see values in your multimeters, change your simulation mode to Interactive and run the simulation.
I hope that helps,
Jeff
National Instruments
10-13-2016 10:19 PM
XMM3 is reading current so must be placed in the circuit. A current meter has very low resistance and when placed across a voltage source effectively shorts the votage source.
10-14-2016 12:39 AM
thanks a lot ...
I figure it out with some experiments of two different PC.
That should be written in multisim manual.
04-03-2022 08:23 PM
Thanks a lot! This helped.