From 04:00 PM CDT – 08:00 PM CDT (09:00 PM UTC – 01:00 AM UTC) Tuesday, April 16, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 

Distorted Wave Voltage on Multisim 13

Sending a wave of distorted voltage at the ends of single voltage source file. This distortion is normal? I'm using Multisim 13.

0 Kudos
Message 1 of 2
(5,317 Views)

Hello.

 

I've tested the circuit in both Multisim 12 and 13, and really in Multisim 12 using the configurations on the oscilloscope you've used, you're able to see the sine signal without the "distortion", however, in the 13 version, if you reduce the timebase, you'll be able to see the signal without this "distortion".

 

I believe that this problem is only visual, but if you really want to be sure, just make a Fourier Analysis to measure frequencies of the harmonics.

 

Regards.

Guilherme Souza
Applications Engineering
National Instruments Brazil
0 Kudos
Message 2 of 2
(5,278 Views)