04-04-2012 12:18 PM
I have a DAQCard NI-4350 (PCMCIA) and am trying to program it. I am running LabView 7
I went to the NI Code Exchange and searched for NI 4350. One of the examples I found was “Maximizing Acquisition Rates with the NI 435X Data Logger Board Maximizing Acquisition Rates with the NI 435X Data Logger Board”.
After I downloaded the file and ran it during the loading an error came up. The error is
Entry Point Not Found
The procedure entry point –pkgModulePackageEventLog@20could not be located in the dynamic link library NIPALU.DLL.
Can any one tell me what is going on and how I can get around it.
Most of the NI 4350 examples I found will not run after I down load them.
Thanks in advance,
John
04-05-2012 07:27 PM
Hello, John!
When programming your 4350, it's important that you have the appropriate drivers installed on your system. In this case, you'll want the following: NI 4350 Device Driver
If you already have this, a re-install may fix the issue, since it should re-create the DLL in question.
If this does not do the trick, please let us know!