Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

USB-6001

Solved!
Go to solution

Hi every one

 I am going to buy NI USB-6001 and using it in Data Aquisition Toolbox Matlab 2016a, 

I need to know is it possible simoultanously to use Analoge input and analog output ? 

 

Mehdi

0 Kudos
Message 1 of 4
(268 Views)

What exactly do you mean by "simultaneously"?

Please note that you're looking at the "lowest" cost DAQ in NI's portfolio and hence limited by lot.

Santhosh
Soliton Technologies

New to the forum? Please read community guidelines and how to ask smart questions

Only two ways to appreciate someone who spent their free time to reply/answer your question - give them Kudos or mark their reply as the answer/solution.

Finding it hard to source NI hardware? Try NI Trading Post
Message 2 of 4
(239 Views)

Dear Santhosh,

Thank you for your reply

I want to make a hardware in loop as closed loop pid controller in matlab simulink using data aquisition toolbox blocks model to measure voltage from temp sensor through analog input of the usb6001 and apply control signal to actuator device through Analog output of thd usb6001

 

Mehdi

0 Kudos
Message 3 of 4
(149 Views)
Solution
Accepted by topic author Mehdi_ab13

In your case, you will read the temp using Analog Input, then do some calculations, then generate a voltage on Analog Output. These are still single-point operations, and that is possible.

 

Please do note that implementing PID on software is not the fastest, and your loop time will be very slow. depending on what exactly you're controlling, it may or may not work.

Santhosh
Soliton Technologies

New to the forum? Please read community guidelines and how to ask smart questions

Only two ways to appreciate someone who spent their free time to reply/answer your question - give them Kudos or mark their reply as the answer/solution.

Finding it hard to source NI hardware? Try NI Trading Post
Message 4 of 4
(127 Views)