From 04:00 PM CDT – 08:00 PM CDT (09:00 PM UTC – 01:00 AM UTC) Tuesday, April 16, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards Multifunction DAQ Topic

Multifunction DAQ

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

NI-DAQmx controls not present in vesion 2012

Solved!
Go to solution

NI-DAQmx controls not present in vesion 2012

‎07-17-2014 12:32 PM

In my older version of Labview 8.6, I have NI-DAQmx controls, however, in the latest Labview 2012 that I have, I don't have them.  Do I need to re-install them for them to show up in version 2012?

0 Kudos
Message 1 of 4
(3,786 Views)
Reply
Solution
Accepted by topic author Bernadette

Re: NI-DAQmx controls not present in vesion 2012

‎07-17-2014 01:15 PM

Yes.  Device drivers must be installed after the development enviornment to install support for the drivers.


"Should be" isn't "Is" -Jay
0 Kudos
Message 2 of 4
(3,782 Views)
Reply

Re: NI-DAQmx controls not present in vesion 2012

‎07-17-2014 01:21 PM

Thank you.

0 Kudos
Message 3 of 4
(3,776 Views)
Reply

Re: NI-DAQmx controls not present in vesion 2012

‎07-17-2014 01:41 PM

According to this white paper, there is no version of DAQmx that will work with LabVIEW 2012 and LabVIEW 8.6.  You can have the DAQmx for either one or the other.

GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
0 Kudos
Message 4 of 4
(3,774 Views)
Reply