How much power can I get out of my SCB-68 connector block?

[MEMSpoweruser]

I was able to connect LabVIEW to an oscilloscope and measure a signal, thanks for the help Filipe and AVR. Now I want to hook my SCB-68 connector block to a peltier cooler and control it using LabVIEW. I need at least 20 volts and .01 amps. I'm using a PCI 6052E I/O board. Any idea how much power I can get out of this setup??

[RobertoBozzolo]

6052E board outputs follow TTL standards, that is they give 5V and more or less 10 mA. You cannot drive your device with these figures: you must use an intermediate relay capable of switching the power required.
Roberto