Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

Help on Selection of a suitable PCI/DAQ Hardware setup

Hi,

I am doing a project which involves 2 different sensors with different Sampling Rates.

My Encoder needs a Sampling Rate of 6.25MHz & my analog sensors needs 100KHz Sample Rate.

Can someone please Guide me how to select a suitable NI Hardware(PCI/DAQ)...!!!

 

 

0 Kudos
Message 1 of 4
(679 Views)

Assuming that the encoder can be interfaced by a counter and that the number of analogue signals is limited, a multifunction I/O device will be suitable. As the sampling frequency of the analog inputs of the following cards depends on the number of channels, these models are suitable for 100kHz acquisition:

  • ≤ 2: PCIe-6321

  • ≤ 5: PCIe-6341
  • ≤ 10: PCIe-6351
0 Kudos
Message 2 of 4
(656 Views)

Hi,

Thank You for the suggestion.

Will the Encoder Sampling Rate be achieved (6MHz)..?

If i connect it to a 8 channel DAQ/CDAQ, can each channel acquire data in different Sampling Rate...?

 

0 Kudos
Message 3 of 4
(635 Views)

Before choosing a multiplexed input DAQ, have a close look at the specification (settle time error)  and check if your signal sources are low impedance.

I had too many problems with such cards while reading multiple channels, so I always try to avoid multiplexed inputs and choose simultainious sampling DAQ.

 

Greetings from Germany
Henrik

LV since v3.1

“ground” is a convenient fantasy

'˙˙˙˙uıɐƃɐ lɐıp puɐ °06 ǝuoɥd ɹnoʎ uɹnʇ ǝsɐǝld 'ʎɹɐuıƃɐɯı sı pǝlɐıp ǝʌɐɥ noʎ ɹǝqɯnu ǝɥʇ'


0 Kudos
Message 4 of 4
(618 Views)