From 04:00 PM CDT – 08:00 PM CDT (09:00 PM UTC – 01:00 AM UTC) Tuesday, April 16, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

Connecting Floating differential and Voltage divider to NI9205

Hi,

 

Please find below my wiring configuration, I have a couple of questions about that - Kindly help with the same

 

  1. I want to connect two floating sources as differential measurement and as suggest  in the manual, I'm also connecting 1Meg to COM terminal - Please confirm if my understanding is correct
  2. In one of the floating sources the voltage range to be measured is around 50V, So I'm planning to put a simple voltage divider and then take it NI-9205 and configure this also as differential - will this work or if there is any downside to the same
  3. I have a couple of grounded single-ended measurements to make - Which is configured as NRSE and COM & AISENSE are shorted 

nforce_212_1-1627569846340.png

 

 

Thank you

Naveen

0 Kudos
Message 1 of 1
(643 Views)