Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

CDAQ Sine Wave Analysis

Hi 

 

 

I have a  CDAQ9178, with a 9229 4ch sigma delta analgoue card. 

 

I have two sine waves around 5V pk to pk at a frequency of 10hz. each waveform varies in cycle width and cycle ampltiude. 

 

I am recording 2 seconds of data, sampling at 10Khz. i want to be able to measure the following for each waveform and ouput the data into an array

 

- Cycle Postive width  (for each waveform)

- Cycle Negative width  (for each waveform)

- Postive Amplitude (for each waveform)

- Negative Amplitude (for each waveform)

 

Does any one have any information on how i can do this. Using the DAQMX vi all i get is an average. For the application i need it for 'average' will not work.

 

Thanks 

0 Kudos
Message 1 of 2
(3,570 Views)

Hi JWinstanley,

 

what DAQmx vi are you talking about? If you have a waveform you can use some of vis from Signal Processing >> Waveform Measurement palette for analysis of the signal.

 

Best regards,

CaravagGIO

 

 

0 Kudos
Message 2 of 2
(3,562 Views)